Enron email

Algorithmic Indexing

4 Jan 2002, 19:21 UTC

FW: STORAGE NOTES

From
Steve Thomas steve.thomas@enron.com
To
Steve January, Gary Spraggins, Dave Odneal, David Gaines, Tom Gilbert, controllers.dl-ets@enron.com, Reyna Cabrera, Kent Miller, Sue Neville, Preston Roobaert, Kay Threet
Date
Fri, 4 Jan 2002 11:21:51 -0800 (PST)
Wrenshall is continuing liquefaction and should be at full inventory in early February.  

Garner's York compressor is down.  On Monday they will decide how to proceed.  If they send the unit into the factory, then the current inventory of 1.75 Bcf will be the max for this heating season.

There may have been some misinformation that the minimum order for vaporization at the LNG tanks is 100 mmcfd.  In talking to the LNG operators they say that the following are minimum orders for vaporization:

Wrenshall  -  50 mmcfd

Garner       -  40 mmcfd

This is not the most effiicent operation for their units, but it is manageable.  

The utilization of the SBA Peakers at Carlton can be balanced with the use of Wrenshall LNG as a backstop.  On days when calling SBA Peakers 24 hours in advance is a borderline decision, it may be best to wait and use LNG if the situation warrants it.   In any case, the utilization of Wrenshall is encouraged, to allow them some run time.  Utilization of Wrenshall may be possible more often if the volume coming in is 50 mmcfd rather than 100 mmcfd.

STEVE
Quoted or forwarded from earlier messages
-----Original Message-----
From: 	Henley, Gaynel  
Sent:	Friday, January 04, 2002 10:31 AM
To:	DL-ETS Gas Controllers; Thomas, Steve; January, Steve
Subject:	STORAGE NOTES

Storage Notes January 4, 2002



Cunningham - Maximum Withdrawal 600-610 mm2
                     Maximum Injection 350-355 mm2

Redfield - Target 300-325
              Maximum Withdrawal 400mm2 
              Minimum Injection 250mm2

Lyons - 65-67mm2
***Monday 1/7 they would like to increase rate - will need Bushton to add horsepower

Garner - York Rep. will be there Monday.  Can vaporize at rates as low as 30 - 50mm2 if needed.

Wrenshall - Liquefaction 15-17mm2. Maximum vaporization 300mm2.